Installing the product
17
3
Set the vertical angle of the camera appropriately.
To confirm the camera angle, record a video after installation and check the video using the Alpine
navigation/display audio system or the ALPINE Recording Viewer application. If necessary, adjust the
camera angle again.
2.2 Installing the rear camera
Refer to the following instructions to properly install the rear camera.
2.2.1 Selecting an installation location
Select a location on the rear windshield where there
is no defrost grid wire and the camera can record
the entire rear view.
• For vehicles with a sunshade attached to the rear windshield, you must select a location where using the
sunshade will not interfere with camera operation.
• The adhesive part of the rear camera should not touch the defrost grid.
To Next Page
Loading...
