Alpine DVR-C320R - Securing the Rear Camera

Installing the product
18
2.2.2 Securing the rear camera
Refer to the following instructions to secure the product to the installation location.
1
After determining the installation location, wipe the installation surface of the windshield with a dry
cloth.
Check the installation location before you secure the rear camera to the rear windshield. After
securing the rear camera to the windshield, it is hard to remove the camera or change the installation
location due to the strong adhesive.
2
1
2
➊➊
➋➋
Remove the protective film from the adhesive mount
and camera lens.
Before attaching the rear camera, check the
position of the lens. The TOP label should be
above the lens.
3
Attach the product with the Alpine logo facing inside
the vehicle and press the adhesive tape firmly to
secure the camera.
If the product is installed in reverse, the rear
view will be recorded upside down.
4
Adjust the camera’s vertical angle.