5. Now attach the Pump Body to the Small Panel
with the Screws and attach the Small Panel to the
top of the Small Bucket with four Screws.
6. Next Install the Tubing into the fountain. Each
Piece will attach from Top to bottom of each
bucket. With Pump connecting at the bottom of
the Large Bucket.
7. Gently pour water into the fountain basin, being
careful not to overflow and cause splashing. Make
sure the water completely submerges the pump
and the water runs clear during operation.
NOTE: We recommend that you use distilled water
to prevent scale build-up. The first time you operate the
pump it can take up to 5 minutes for the air to be
completely expelled and water begins to flow properly
8. You can now adjust the water pump to your flow
preference. (see Quick Tip)
9. Congratulations, your fountain is now complete.
Don’t forget to add water regularly as water will
evaporate over time.
To Next Page
Loading...
