8. Plug the pump into your local power supply. Make
sure that there is no water around the plug &
always keep the power source in a dry place.
9. Congratulations, your fountain is now complete.
Don’t forget to add water regularly as water will
evaporate over time.
• Power Head Pump ……………………P280
• Fountain Care Formula…………….....PPL102
Foam and scale remover for indoor and outdoor fountains.
• Americana® UV Acrylic Sealer ...……RRR106
Provides protective clear coating for all painted surfaces.
• Touch Up Paint Kit....…………….…....RTD102
Includes primer, thinner, 7 paint colors, applicator and sealer.
3. Place the pump into the Large Bucket, and then
place the Medium Bucket with the attached Large
Panel on top of it. The metal Large Support bar
will rest under the Large Panel on top of the Large
Bucket. This will be secured once the screws are
tight. Use four of the Screws to secure the Large
Panel to the Large Bucket Note: Be sure the
cord is routed through the cord slot in the back.
Now repeat this process for Small Bucket with the
attached Medium Panel. Again, place the Small
Support bar in place and attach the Small Bucket.
4. Attach the pump Handle to the Pump Body by
lining up the screw holes and securing a Screw.
To Next Page
Loading...
