Alpine X800D - Setting the AUX3 Sel. (Switching the Visual Input Signal System); RSE Setting; Setting the Rear Seat Entertainment System; Tuneit Setting

63-EN
Usable 4-pole mini AV plug
The unit accepts the following 4-pole mini AV plug pin-out:
• Please check pin-out carefully before use of this product. Depending
on the cable, there may be no picture and/or sound.
• When an iPod video is selected or the current source is AUX3, this
setting cannot be adjusted.
After setting to “AUX3” in “Setting the AUX3 In Sel.”, this setting can
be carried out. The video input type can be changed.
Setting item: AUX3 Signal
Setting contents: Auto (Initial setting) / NTSC/PAL
• When the current source is AUX3, this setting cannot be adjusted.
RSE Setting
[RSE] is selected on the Source setup menu in step 3. Refer to “Source
Setup Operation” (page 58).
Video and audio can be output to the rear monitor.
Setting item: RSE
Setting contents: Off (Initial setting) / On
• If you selected the “On” setting, set the “Remote Sensor Setting”
(page 47).
TuneIt Setting
[TuneIt] is selected on the Source setup menu in step 3. Refer to
“Source Setup Operation” (page 58).
Set TuneIt to USB (iPhone) when an iPhone is connected, or set to BT
(Android) when an Android smartphone is paired.
Setting item: TuneIt
Setting contents: Off / USB (iPhone) (Initial setting) /
BT (Android)
*
* Not displayed when BLUETOOTH is set to Off. For details, refer to
“BLUETOOTH Setting” on page 64.
• For this function to work properly, specific applications must be
installed on your smartphone before connection. Consult your Alpine
dealer or the Alpine website for details.
• Only the iPhone and certain Android smartphones support this
function.
Setting the AUX3 Sel. (Switching the Visual
Input Signal System)
Auto: The video input signal type (NTSC or PAL) will
be automatically selected.
NTSC/PAL: Choose the video input signal type manually.
Setting the Rear Seat Entertainment
System
Audio L (White)
Audio R (Red)
Ground
Video (Yellow)
Setting the Communication Mode with a
smartphone
Off: No smartphone is connected.
USB (iPhone): When an iPhone is connected to the unit’s
USB port, you can programme the unit’s sound
tuning parameters, or communicate with SNS.
BT (Android): Set this when an Android smartphone is paired
with this unit via BLUETOOTH technology. And
after BLUETOOTH Audio is connected, you
can programme the unit’s sound tuning
parameters, or communicate with SNS.