Alpine X800D - AUX CAMERA AND REVERSE SETTINGS; AUX CAMERA CONFIGURATION

68-EN
AUX Camera Setting
[AUX Camera] is selected on the Camera setup menu in step 3.
Refer to “Camera Setup Operation” (page 66).
Setting item: Camera Select / Camera Signal*
1
Setting contents: Off (Initial setting) / Rear*
2
/ OTHER
*
1
If “Camera Select” is set to “Off”, this option is not available.
*
2
If “Camera Select” in Direct Camera Setting is set to “Rear”,
“Rear” cannot be set in AUX Camera Setting.
Setting the AUX Camera Signal Input
When the AUX camera is connected, the video input signal type can be
chosen.
Further setting item: Camera Signal
Setting contents: NTSC (Initial setting) / PAL
Camera Interrupt Setting
(Power OFF Mode)
[Camera Interrupt] is selected on the Camera setup menu in step 3.
Refer to “Camera Setup Operation” (page 66).
You can set whether to display the rear camera image when the gear
lever is moved to the reverse (R) position while the unit is turned off.
Setting item: Camera Interrupt (Power OFF Mode)
Setting contents: Off /On (Initial setting)
Reverse Mute Setting
[Reverse Mute] is selected on the Camera setup menu in step 3. Refer
to “Camera Setup Operation” (page 66).
You can set whether to mute the playing music when the gear lever is
moved to the reverse (R) position.
Setting item: Reverse Mute
Setting contents: Off / On (Initial Setting)
Setting the Camera Input
Rear: Rear camera
OTHER: Side camera, Room camera, etc.
Off: The rear camera image is not displayed
On: The rear camera image is displayed
Off: Continue playing music even though the gear lever is
moved to the reverse (R) position.
On: The playing music is muted when the gear lever is moved
to the reverse (R) position.