Equipment end of life
Management of SF
6
gas
P80--0002EN/02
5/6
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Transportation of SF
6
gas
D Transportation of SF6 gas is considered as a transportion of dangerous
materials. It must be carried out in accordance with the regulations in force,
especially the ADR Regulations in Europe (European Agreement concerning
the International Road Transport of dangerous materials).
D For each transport, each container must be labelled, the label must be
visible and be combined with a Health & Safety / Transportation label and a
T ransportation slip for dangerous materials must be drawn up.
D In the event of a transportation of SF6 gas containing toxic products
(waste), the document for dangerous materials must include the ADR 2.2 T
C classification with a Safety Plan. The combined label will be the following :
S 7/9 – Keep container tightly closed in a well-- ventilated place.
S 20/21 – When using, do not eat, drink or smoke.
S 38 – In case of insufficient ventilation, wear suitable respiratory equipment.
S 45 – In the event of an accident, contact a doctor immediately (if possible
show the doctor this label).
S 61 -- Avoid release to the environment. Refer to special Instructions / Safety
Data Sheet.
S 63 – If inhaled, move the victim out of the contaminated area and keep them
still.
S 51 -- Use only in well ventilated areas.
(Contains used Sulphur Hexafluoride SF6)
R 26/27/28 – VERY TOXIC BY INHALA TION, IN
CONTACT WITH SKIN AND IF SWALLOWED.
C-- CORROSIVE
T+ -- VERY TOXIC
Liquid
GAS,
toxic,
corrosive,
n.s.a.
USED SF6 SULPHUR
HEXAFLUORIDE
D Loading and unloading operations are carried out by trained and qualified
personnel in accordance with the instructions in force.
To Next Page
Loading...
