Installation
Tightening torque values
P31--0001EN/02
1/4
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Presentation
Introduction
During fastener assembly, all fixation bolts must be ”greased” before
torque tightening.
Products used
The following table provides the list of products used for the fasteners
before tightening:
Description Reference
ALSTOM Grid
Supplier Reference
supplier
Grease
--01835208
(1kg box)
MOBIL OIL
MOBILPLEX 47
MOBILUX EP3
Contact
grease
--01835118
(200g tube)
EPMF
CONTACTAL
HPG
Silicon
grease
--01835265
(100g tube)
SAMARO MOLYKOTE 111
Glue
--01818327
(250 ml)
LOCTITE LOCTITE 225
In this module
This module covers the following subjects:
Subject Page
Greasing the fasteners before tightening 2
Torque tightening values 3
To Next Page
Loading...
Need help?
General
