Maintenance
Control of contact densimeter thresholds
P51--1001EN/03
1/8
07--2012
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Presentation
Tools required
List of ALSTOM Grid tools necessary for the operation:
Mark Illustration Description Reference Quantity
(11)
Manometer
0...0,765 MPa
HBL--02842117
+
HB0005499001
1
Manometer
0...1 MPa
HBL--02842118
+
HB0005499001
(17)
Mano--relief valve
0...1 MPa
HBL--02557392
+
HBLN55161601
1
(5)
Connection valve
block
HB0005649001 1
Setofseals HB0000270121 1
Test lamp HBL--02861501 1
In this module
This module covers the following subjects:
Subject Page
Preparation of the densimeter 2
Connecting the densimeter to the inspection tools 3
Checking densimeter thresholds 4
Re--installation of the densimeter 6
Storage of the checking tools 7
Special case with two densimeters 8
To Next Page
Loading...
Need help?
General
