Installation
Verification o f th e presence of SF
6
gas in the poles
P31--0501EN/03
2/4
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Checking the poles o n o pen in g the cases in--site
Preparing the pole
Only remove the cover of the case
. Partially remove the packaging
protection in order to be able to reach the pole casing (7).
7
Examining the poles
D Proceed with a visual inspectionof the state of the porcelain. Make sure
the transport did not give rise to significant bursts or deterioration of the
enamel.
D It is indispensible to check for the presence of SF
6
gas in the pole
components before continuing with the installation.
To Next Page
Loading...
Need help?
General
