Installation
Mounting the operating mechanism
P31--7901EN/02
4/8
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Coupling the operating mechanism, continued
Coupling
The table below shows the steps for coupling the operating mechanism:
Step Action Remark
1 Sling the operating
mechanism using the hoisting
strap (1) as shown in the
illustration.
1
2 Lift up the operating
mechanism and place it level
.
3
Bring the operating
mechanism to installation
position.
The final approach must be
performed with care.
4 Insert the pin of the operating
mechanism (13) into the
sleeve (12).
13
12
5 D Place the washers (10) and
nuts (14), and then tighten to
the indicated torque value.
D Remove the hoisting strap.
x4
HM16
18 daN.m
14
10
To Next Page
Loading...
