What does 'PCB over temperature' mean on my Alto-Shaam 300-TH?
If your Alto-Shaam oven displays a 'PCB over temperature' error, it means the PCB board temperature sensor is over 70° C. The possible causes are: 1. Cooling Fan not operating 2. Installation clearance requirements not met
Why does my Alto-Shaam 300-TH Oven say 'USB error (USB not present)'?
If your Alto-Shaam oven shows a 'USB error (USB not present)' message, it means that the USB is not detected. Try inserting the USB or using a different USB cable.
What does 'Under-voltage' mean on an Alto-Shaam 300-TH?
If your Alto-Shaam oven displays an 'Under-voltage' error, it indicates that the supply voltage is incorrect. You should correct the supply voltage.
What causes the 'Over-voltage' error on my Alto-Shaam 300-TH, and how to fix it?
If your Alto-Shaam oven displays an 'Over-voltage' error, it means the supply voltage is incorrect. Correct the supply voltage to resolve this issue.
What to do if my Alto-Shaam 300-TH Oven displays 'Check fans' error?
If the Alto-Shaam oven displays a 'Check fans' error, it indicates insufficient internal cooling airflow. The possible causes are: 1. Cooling fan filters dirty 2. Cooling fans not operating 3. Installation clearance requirements not met
How to fix the 'Door open' error on my Alto-Shaam oven?
If the Alto-Shaam oven displays a 'Door open' error, it means the door is not closed properly. Ensure the door is fully closed and check the door switch operation.
What does 'Bootloader EEPROM RAM reset' mean on Alto-Shaam 300-TH?
If your Alto-Shaam Oven displays a 'Bootloader EEPROM RAM reset' error, it indicates a bootloader chip error. A power cycle is required to reset the system.
General| Model | 300-TH |
|---|---|
| Category | Oven |
| Brand | Alto-Shaam |
| Power Source | Electric |
| Capacity | 3 full-size sheet pans |
| Control Type | Digital |
| Electrical | Single Phase |
To Next Page
