Why is my Alto-Shaam 300-TH showing a 'PCB over temperature' error?
If your Alto-Shaam Oven shows a 'PCB over temperature' error, it means the PCB board temperature sensor is over 70° C. This can be caused by: 1. Cooling Fan not operating. 2. Installation clearance requirements not met.
What does 'Bootloader EEPROM RAM reset' mean on Alto-Shaam 300-TH?
If your Alto-Shaam Oven displays a 'Bootloader EEPROM RAM reset' error, it indicates a bootloader chip error. A power cycle is required to reset the system.
How to fix the 'Door open' error on my Alto-Shaam oven?
If the Alto-Shaam oven displays a 'Door open' error, it means the door is not closed properly. Ensure the door is fully closed and check the door switch operation.
What to do if my Alto-Shaam 300-TH Oven displays 'Check fans' error?
If the Alto-Shaam oven displays a 'Check fans' error, it indicates insufficient internal cooling airflow. The possible causes are: 1. Cooling fan filters dirty 2. Cooling fans not operating 3. Installation clearance requirements not met
What to do if Alto-Shaam 300-TH Oven shows 'USB error (USB not present)'?
If your Alto-Shaam Oven is showing a 'USB error (USB not present)', insert the USB drive. If the error persists, the USB cable may be faulty.
What to do if the Alto-Shaam Oven door is open?
If the Alto-Shaam Oven door is open, close it and check the door switch operation.
What does 'PCB shorted' mean on my Alto-Shaam 300-TH display?
If your Alto-Shaam oven displays a 'PCB shorted' error, it indicates that the PCB board temperature sensor is short-circuited, which means board failure.
What does 'PCB open' mean on my Alto-Shaam oven?
If your Alto-Shaam oven displays a 'PCB open' error, it means that the PCB board temperature sensor is open-circuit, indicating board failure.
What does 'Probe 1 short' mean on Alto-Shaam 300-TH Oven?
If the Alto-Shaam oven displays a 'Probe 1 short' error, it signifies a short circuit detected on the sensor wires. Check: 1. Sensor connection circuit, upper 2. Sensor compartment 3. Control Board
How to fix 'Bootloader EEPROM RAM reset' on Alto-Shaam 300-TH Oven?
If your Alto-Shaam oven displays a 'Bootloader EEPROM RAM reset' error, it indicates a bootloader chip error. You need to power cycle the oven to reset it.
General| Model | 300-TH |
|---|---|
| Category | Oven |
| Brand | Alto-Shaam |
| Power Source | Electric |
| Capacity | 3 full-size sheet pans |
| Control Type | Digital |
| Electrical | Single Phase |
To Next Page
