MAINTENANCE
Del uxe Contr ol Cook & Hold ▪ Ser vic e Manua l ▪ MN- 4671 2 ▪ R ev 01 ▪ 1 1/ 20
42
Continued from previous page
▪ Check and tighten the cord connection inside of the appliance control area.
▪ Inspect the control cooling fans (if applicable).
▪ Measure the site voltage.
▪ Inspect and adjust voltage monitor board if needed.
▪ Inspect and test the product probe and product probe receptacle.
▪ Inspect and test the control and control functions.
▪ Inspect the cavity for structural integrity.
▪ Inspect the door gaskets for correct shape and seal. Replace/repair as needed.
▪ Inspect the door handle and hinges. Replace/repair as needed.
▪ Inspect the full perimeter bumper.
▪ Inspect the casters.
▪ Do a cavity temperature calibration procedure per manufacturer’s
recommendations.
To Next Page
Loading...
