SERVICE
MN-28657 (Rev 1) 03/15 • AR-7E Rotisserie • 24
Part numbers and drawings are subject to change without notice.
Disconnect unit from power source
before cleaning or servicing. Failure
to observe this precaution can cause
electrical shock and personal injury.
Electrical connections must be made
by a qualified and trained service
technician in accordance with
applicable electrical codes. Failure to
observe this precaution may result in
electrical shock, fire, damage to the
appliance or personal injury.
DANGER
LOCK-OUT OR POST
BREAKER PANEL UNTIL
SERVICE WORK HAS
BEEN COMPLETED.
CAUTION
This section is provided for the assistance of
qualified and trained service technicians only
and is not intended for use by untrained or
unauthorized service personnel. Failure to observe
this precaution may void the warranty.
BULB REPLACEMENT INSTRUCTIONS
A. Remove four screws holding glass light
cover (CV-26607) and gasket (GS-26609)
in place, taking care to not let the glass
cover (GL-26608) fall into the oven.
B. Pull bulb out.
C. Push replacement bulb (LP-34213) in place.
D. Re-install glass cover and gasket, securing
with four screws removed in step one.
B & C
D
The performance of this unit has
been optimized using the factory
provided bulbs. These bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb fi lament.
DO NOT HANDLE NEW BULB WITH
BARE HANDS. WHITE COTTON
GLOVES SHOULD BE WORN WHEN
REPLACING BULBS.
To Next Page
Loading...
