INSTALLATION
Ve ct or F ® Se ries ▪ O pera to r’s Man ual ▪ MN-468 94 ▪ Rev 1 ▪ 7/2 0
29
Continued from previous page
7. Remove the knockout plate d.
Remove the necessary knockout from the knockout plate.
8. Slide the supply cord e through the cord grip.
Install the supply cord and cord grip into the knockout plate f.
9. Re-install the knockout plate. Do not tighten the cord grip sealing nut.
Install the supply cord into the oven far enough to reach the ground
terminal block.
Continued on next page
To Next Page
Loading...
