11
Operating instructions GB
3.3 Operation
Always hold the spray lance with both
hands!
Always lock the spray handle when the
cleaner is not in operation.
Activate the high pressure washer by releasing the trigger of the spray handle (1). When starting up the
machine the pressure may be unsteady because of air in the pump system. After a short time the air
will escape from the system and the pressure will become steady. When the cleaner is not in use,
secure the spray handle by turning the safety knob (2) into pos. 0.
3.4 Temperature control
Cold water mode 0 - 50°C
Hot water mode 50 - 95°C
Steam mode 95 - 150°C
Adjust the temperature control (1) to the required temperature.
An indicator light on the temperature sensor (2) shows the actual temperature of the outlet water. If the
machine is put away immediately after hot water or steam operation, it should be cooled off at first by
„cold water operation“ until the temperature is below 50°C.
IMPORTANT: Adjustment at temperatures above 95°C should be made with released spray handle.
When choosing temperatures above 95°C the water volume is automatically reduced. Then
full water
volume
at temperatures below 95°C cannot be obtained until the temperature of the outlet water has
fallen below 95°C. Upon that release the spray handle to have full water volume again. The cooling
period, from max. temperature (150°C) to full water volume is approximately 1 minute.
2
1
3840HA_EU.p65 28-02-01, 11:2411
To Next Page
Loading...
Need help?
General
