13
Operating instructions GB
NOTE:
If the machine stops because of a problem with the burner, a “failure code” will flash and the machine will
stop. If the code is
other than
an “A-code”, try to restart the machine as follows:
1. Disconnect the power to the machine. Try to restart it normally, or call for service, or...
Burner override mode
2. Turn the temperature control knob all the way to the COLD position (fully counter clockwise). Hold the
START button down for approximately 3 seconds. The machine will start as a cold water machine and will
ignore burner failure codes. In this mode, all burner operations are disabled and it will not be possible to
re-establish these operations until the power to the machine has been disconnected and the cause of the
original burner fault is corrected.
Always call for a service technician to correct the failure in the burner system as soon as possible! Burner
Override Mode is only to be used as a temporary solution.
3.7 Transport directions
For lifting by crane, use lifting straps!
When transporting the machine (lifting by crane) a lifting strap should be used.
Place the straps by the castor wheel and the shaft of the driving wheels -
never under the tank!
Always fasten the machine securely during transport. The brake of the castor wheel (8) should be applied
during transport.
3.8 Storage
Frost-free room or anti-freeze solution!
We recommend you to store the machine in a frost-free room between cleaning tasks. The machine
must be emptied of water prior to storing for a longer period. This is done in the following way:
1. Detach water hose. Dismount spray lance and empty it of water.
2. Start the machine, and let it run with open spray handle until all water has run out.
If the store room is not frost-free, the machine should be protected with an anti-freeze solution, See
accessories catalogue and follow the instructions for the accessory.
3840HA_EU.p65 28-02-01, 11:2513
To Next Page
Loading...
Need help?
General
