Run the output of the console at a level below 0dBu
This solution means that you won't get full benefit of the console, and may suffer a reduced signal to noise ratio
especially when running over long signal cables. But the amplifiers should be saved from clipping.
As with many things in the audio world, use your ears. If something sounds distorted check:
Input Gain too high?
(lower input gain and check)
EQ Too Much Boost?
(disable EQ and check)
EQ Too Much Cut coupled with a High Input Gain?
(disable EQ and check)
Too High a level into Inserted Processor?
(disable insert and check)
Clipping Loudspeaker controller or Amplifiers? (Check both CLIP LEDs)
37
To Next Page
Loading...
Need help?
General
