50
CLUB - 4 FX & 4 stage monitors - 4 different listening zones
Aux sends settings:
Aux is post fader, and its signal is addressed to fx unit, whom return is connected to stereo Aux Return 1
Aux is post fader, and its signal is addressed to fx unit, whom return is connected to stereo Aux Return 2
Aux is post fader, and its signal is addressed to fx unit, whom return is connected to stereo Aux Return 3
Aux is post fader, and its signal is addressed to fx unit, whom return is connected to stereo Aux Return 4
Aux are pre-fader, their signals are addressed 4 LTO Elvis Active Monitor A-D
Aux return channels :
to be used for FX unit 1 return
if you're recording your mix you have to disconnect the TAPE RETURN jacks, otherwise you risk a feedback
to be used for FX unit 2 return
to be used for FX unit 3 return
to be used for FX unit 4 return
- In this example the stereo input channels could be used for pre-mixers outputs or stereo sources (CD players, cassette players, tuners, etc.).
Sub-groups assign:
in stereo for zone 1
in stereo for zone 2
in stereo for zone 3
in stereo for zone 4
1
2
3
4
5->8
AUX RETURN 1 -
Warning -
AUX RETURN 2 -
AUX RETURN 3 -
AUX RETURN 4 -
NOTE
groups 1-2
groups 3-4
groups 5-6
groups 7-8
To Next Page
Loading...
