18
RUN COMPLETION
In order use the run completion program effectively at least one previous
run must be entered into a data base with a 1000’ ET. To use run
completion all you need to do is enter the 1000’ et of the run you want to
complete and then when it asks you to enter your final ET= simply press
the enter key without any value. You will then see a Run Completing!
message appear followed by ET=10.203 (example) your completed ET.
This run will then be saved automatically and the main menu will be
brought back, unless you are in TS mode, in which case, you will then be
prompted to enter your TS. Run Completing is an approximation and it
is NOT suggested to base a prediction on this type of data. Actual all out
runs typically prove for more accurate predictions.
1/8 Mile Tracks
Keep 1/8 mile and 1/4 mile runs in separate data bases. You may want
to name the data base appropriately.
If you run 1/8 mile and want to be able to use run completion you must
enter in a 330’ time when the unit prompts you to enter the 1000’ time.
In regards to entering your ET for a 1/8 mile track simply enter in the 1/8
mile time.
To Next Page
Loading...