Alutech CU-TR230-868 - Cycle Counter Data

CONTROL UNITS UTR230868 / UTR400868 2727
SETTINGS
6.5 CYCLE COUNTER DATA
Y
The number of completed cycles in a six-digit form is displayed in the setting when changing
the display inscription (maximum 999,999 cycles).
The example shows the counter value 123 456 cycles:
.
Table16
1
Press and hold
for ~5 s, until entering the setting menu
5 s
2
After the inscription P1 appears, press
3
After the inscription P0 appears, press
4
After the inscription F0 appears, press
5
After the inscription F1 appears, press
6
The display will show two digits with two dots (for example, 1.2.).
Theseare the rst two digits of the counter.
In order to see the next two digits of the counter (third and fourth)
press
7
The display will show the next two digits with one dot in the middle
(forexample, 3.4).
In order to see the last two digits of the counter (fth and sixth)
press
8
The display will show the last two digits with one dot at the end
(forexample, 5 6.).
Using
or it is possible to see the counter digits again
9
To exit the setting menu, press 3 times
×3