Need help?Do you have a question about the Alutech CUID-400N and is the answer not in the manual?
General| Brand | Alutech |
|---|---|
| Model | CUID-400N |
| Category | Control Unit |
| Language | English |
Configures door operation logic: manual, semi-automatic 1/2, and automatic modes.
Configures delay for drive movement start and lamp illumination.
Sets up testing of safety devices like photocells before door closing.
Defines the duration for full door opening or closing.
Sets the pause duration before the door automatically closes.
Selects the type of lower margin safety sensor (OSE or resistive).
Instructions for using the AT-4 remote control, including mode selection limitations.
Procedures for recording and deleting AT-4N/AT-4A remote controls.
To Next Page
