MH-1201A
1. Special Precautions
1-3
Apply the specified source voltage
Application of a voltage out of the specified range can cause fire and electric
shock.
Do not splash water on the Welding Head
Water splashed over the electric parts can cause electric shock and short
circuits.
Install the Welding Head on firm, level surface.
If the Welding Head falls or drops, injury may result.
Keep combustible matter away from the welding machine.
Surface flash and expulsion can ignite combustible matter. If it is impossible to
remove all combustible matter, cover them with non-combustible material.
Do not cover the Welding Head with a blanket, cloth, etc.
If such a cover is used, it may be overheated and burn.
Keep a fire extinguisher nearby.
Keep a fire extinguisher in the welding shop in case of fire.
Maintain and inspect the Welding Head periodically.
Maintain and inspect the Welding Head periodically, and repair any damage
nearby before starting operation.
Protective gear must be worn
Put on protective gear such as protective gloves, long-sleeve jacket, leather
apron, etc. Surface flash and expulsion can burn the skin if they touch the skin.
Do not use this Welding Head for purposes other than welding
Use of this Welding Head in a manner other than specified can cause electric
shock and fire.
CAUTION
！
To Next Page
Loading...
