MH-1201A
1. Special Precautions
1-4
(2) Precautions for Handling
■ Do not install this Welding Head in the following:
・Damp places where humidity is 90% or higher,
・Dusty places,
・Places where chemicals are handled,
・Places near a high noise source,
・Hot or cold places where temperatures are above 40°C or below 5°C, and
・Places where water will be condensed.
■ Clean the outside of the Welding Head with a soft, dry cloth or one wet with a
little water. If it is very dirty, use diluted neutral detergent or alcohol. Do not use
paint thinner, benzine, etc., since they can discolor or deform the Welding Head.
■ Do not put anything other than a workpiece, e.g., a tool, a screw, etc., between
the electrodes. It can cause serious trouble.
■ Do not put a screw, a coin, etc., in the Welding Head, since they can cause a
malfunction.
■ Operate the Welding Head according to the method described in this operation
manual.
(3) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time of
disposal, separate it from general industrial waste or domestic waste and carry out
the disposal in accordance with applicable laws and regulations.
To Next Page
