CT-110D
1.Special Notes
1-4
(2) Precautions for Handling
Install the Controller securely on a firm and level surface, to ensure that it will not fall.
Do not install the Controller in the following locations:
Damp areas (where the humidity is above 90%), areas where chemicals are handled, dusty areas,
areas near a high noise source, areas where water may condense, areas exposed to large amounts
of vibration or shock, and areas where temperatures are above 45C or below 0C
Clean the exterior of the Controller using a soft, dry cloth or one slightly dampened with water. If the
Controller is very dirty, use diluted neutral detergent or alcohol. Do not use paint thinner, benzine, etc., as
they may discolor or deform the Controller.
Do not insert a screw, coin, etc. into the Controller, as they may cause a malfunction.
Operate the Controller in accordance with the method described in this operation manual.
Press switches/buttons carefully by hand. Handling them roughly (using a screwdriver or the tip of pen)
may result in a malfunction or failure.
Press switches/buttons one at a time. Pressing more than one switch/button at a time may result in a
malfunction or failure.
(3) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time of disposal,
separate it from general industrial waste or domestic waste and carry out the disposal in
accordance with applicable laws and regulations.
To Next Page
