PRODUCT IDENTIFICATION
2 Rev. 1
The model and manufacturing number are used for positive identification of component parts used in manufacturing.
When engineering and manufacturing changes take place where interchangeability of components are affected, the manu-
facturing number will change.
It is very important to use the model and manufacturing numbers at all times when requesting service or parts information.
IF REPAIRS ARE ATTEMPTED BY UNQUALIFIED PERSONS, DANGEROUS
CONDITIONS (SUCH AS EXPOSURE TO ELECTRICAL SHOCK) MAY RE-
SULT. THIS MAY CAUSE SERIOUS INJURY OR DEATH.
AMANA WILL NOT BE RESPONSIBLE FOR ANY INJURY OR PROPERTY
DAMAGE ARISING FROM IMPROPER SERVICE OR SERVICE PROCE-
DURES. IF YOU PERFORM SERVICE ON YOUR OWN PRODUCT, YOU ASSUME RESPONSIBILITY FOR
ANY PERSONAL INJURY OR PROPERTY DAMAGE WHICH MAY RESULT.
WARNING
WARNING
Product Type
G: Gas Furnace
Supply Type
U: Upflow/Horizontal
Airflow Capability
30: 3.0 Tons
40: 4.0 Tons
50: 5.0 Tons
Nominal Input
045: 45,000 Btuh
070: 70,000 Btuh
090: 90,000 Btuh
115: 115,000 Btuh
140: 140,000 Btuh
Model Family
D: Air Command 80 SV Category 1
Design Series
C: Third Design Series
D: Fourth Design Series
G U I D 045 C A 30
Furnace Type
I: Induced Draft (80%)
Additional Features *
A: Not NOx Certified
X: NOx Models
CAUTION
To Next Page
Loading...
