5
•
•
•
to and the service area around the unit must have
Fuel Gas Code (NFPA 54/ANSI Z223.1), and/or CAN/CSA
A copy of the National Fuel Gas Code (NFPA 54/ANSI
25 West 43rd Street, 4th Floor
New York, NY 10036
1 Batterymarch Park
Quincy, MA 02169-7471
8501 East Pleasant Valley
Independence, OH 44131
Contractors of America.
A copy of the CAN/CSA B149.1-15 Installation Codes can
178 Rexdale Boulevard
provided in the Combustion and Ventilation Air
Requirements section when selecting a furnace location.
•
• All other warranty exclusions and restrictions apply
appropriate for use with natural or propane gas
Non-direct vent (single pipe) central forced air furnace in
from air ducted from the outside or,
Direct vent (dual pipe) central forced air furnace in which
through a special air intake system outlined in these
instructions.
• The vent system is permanently installed per these
installation instructions.
• A room thermostat is used to control the furnace.
Fixed jumpers that provide continuous heating
equipment damage. Bi-metal thermostats, or any
during construction.
• Return air ducts are provided and sealed to the
furnace.
•
•
are installed in the system and inspected daily and
replaced as needed during construction and upon
completion of construction.
• The input rate and temperature rise are set per the
furnace rating plate.
•
construction.
• The furnace heat exchanger, components, duct
• All furnace operating conditions (including ignition,
instructions.
•
the furnace is operating in any mode.
• Damage or repairs due to failure to comply with these
requirements are not covered under the warranty.
To Next Page
Loading...
Need help?
General
