What to do if the gas flows to the bake/broil burner, but burner does not light in my Amana AO27DG Oven?
If gas flows to the bake/broil burner but the burner doesn't light, try these steps: * Reposition the ignitor closer to the bake/broil burner. * Clean the orifice to remove any dirt or grease. * Check for correct gas pressure. Natural gas pressure should be 5” WCP and LP gas pressure should be 10” WCP.
How to fix an Amana AO27DG light that is not working?
If the oven light does not operate: 1. Replace the bulb. 2. Check the light switch contacts for continuity. 3. Check for 120 VAC at the light socket terminals. If voltage is present, replace the socket. If no voltage is present, check for broken wiring between the hot terminal block and light switch and between light switch and socket.
What to do if there are no timed bake or broil operations on my Amana AO27DG Oven?
If there are no timed bake or broil operations, but manual bake and broil operate normally: 1. Check for 120 VAC at clock terminal 12 to neutral. If no voltage is present, check for broken wiring. If voltage is present, proceed to the next step. 2. Check clock contact for continuity or check for 120 VAC at clock terminal 11 to neutral. If open contact is indicated, replace the clock. If voltage is present at terminal 11, proceed to the next step. 3. Check for 120 VAC at selector switch terminal 4 to neutral. If no voltage is present, check for broken wiring. If voltage is present, proceed to the next step. 4. Check selector switch contacts for continuity.
What to do if there is no oven operation in manual bake or broil on my Amana AO27DG Oven?
If there is no oven operation in manual bake or broil, but timed bake and broil operate normally: * Check for 120 VAC at selector terminal 6 to neutral. If no voltage is present, check for broken wiring. * Check selector switch contacts for continuity, because there is no voltage to the selector switch or the selector switch contacts have failed.
What to do if no gas flows to the burner, but the ignitor glows red in my Amana AO27DG?
If no gas flows to the burner, but the ignitor glows red, check the ignitor current draw and replace the ignitor if it fails the test. Also, check for correct gas pressure. Natural gas pressure should be 5” WCP and LP gas pressure should be 10” WCP.
Why is the fan motor not working in my Amana AO27DG?
If the fan motor does not operate: * Check for 120 VAC supplied at the fan motor. If no voltage is present, check the selector switch and clock contacts for continuity and check for broken wiring between the selector and fan motor and between the clock and selector switch. * If voltage is present at the fan motor, check the motor winding for continuity, check for a frozen motor shaft, and check for broken wiring between the motor and the neutral terminal block.
Why doesn't the oven indicator light come on in my Amana AO27DG Oven?
If the oven indicator light does not come on: * Check for broken wiring between the thermostat and indicator and from the indicator to the neutral terminal block. * Check for 120 VAC at the indicator terminals. If voltage is present, replace the indicator.
How to fix an Amana AO27DG Oven light that stays on?
If the oven light stays on, check the light switch contacts for continuity and replace the light switch if necessary.
Why does the oven lock light cycle on and off during self-clean on my Amana AO27DG?
If the oven lock light cycles on and off during self-clean, cleaning is poor, and bake and broil functions operate normally, check for 120 VAC at the clean relay terminal 6 to neutral. If no voltage is present, check the clean relay contacts and top latch switch contacts for continuity. If contacts are closed, check for broken wiring between the thermostat and latch switch and between the latch switch and relay. If voltage is present, check for broken wiring between the clean relay and the ignitor because the bake circuit is not being completed at self-clean temperatures above 650°-700°.
Why does the broil burner shut off shortly after the start of self-clean operation in my Amana Oven?
If the broil burner shuts off shortly after the start of self-clean operation, but bake and broil functions operate normally, check both sail switch contacts for continuity because the sail switch contacts are not closing.
General| Brand | Amana |
|---|---|
| Model | AO27DG |
| Fuel Type | Electric |
| Number of Oven Racks | 2 |
| Self-Cleaning | Yes |
| Convection Oven | No |
| Color | Stainless Steel |
| Width | 27 inches |
| Oven Capacity | 4.3 cu. ft. |
To Next Page
