Amana DSA01NM User Manual

3
NOTE: The DSA01NM antenna is not designed to function
with an occupancy sensor (DD01x) or in an RF mesh. If you
require an energy management system or web based moni-
toring, you must install a DT01G RF wireless antenna (sold
separately).
3. BINDING OF RF DEVICE
RF TRANSMITS THROUGH WALLS.
The wireless device, DSA01NM, must be bound to the PTAC
for proper in-room communication. Ensure the PTAC unit is
powered but in the OFF position.
1. Press and hold OFF button on the PTAC until appears.
2. Press and then immediately release the white tactile
button on the back of the DSA01NM thermostat.
should now be displayed on the PTAC LED display. If
does not show on the display in 1-2 seconds, then press
and release the white button a second time. When
appears, press the OFF button on the PTAC to exit the
binding mode.
After the PTAC has finished a diagnostic review and
the LED display is back to a blank screen, proceed to
test the thermostat operation. See the following
DSA01NM GENERAL FUNCTIONS.
WHITE
TACTILE
BUTTON
DSA01NM GENERAL FUNCTIONS
The MODE button, located in the far left corner of the
thermostat, allows the user to choose between off cool and
heat positions.
1. The first push on any button on the thermostat turns
the backlight on.
2. The second push of the MODE button will then allow
the user to cycle through the modes of desired opera-
tion: OFF, COOL or HEAT.
NOTE: What you change on one device will update to the
other.
3. If the thermostat is functioning properly, mount the
thermostat body on the previously installed wall
plate.
4. CONFIGURATION
The PTAC control will automatically self-configure to work
with the wall thermostat (DSA01NM Kit) if installed and
bound.

Amana DSA01NM Specifications

General

Brand	Amana
Model	DSA01NM
Category	Thermostat
Language	English