21
-
Do not
R
C
(Single-Stage Cooling)
R
Figure 28
TO PREVENT
UNRELIABLE OPERATION OR EQUIPMENT
DAMAGE, THE
GAS MANIFOLD PRESSURE
MUST BE AS SPECIFIED ON THE UNIT RATING
PLATE. ONLY MINOR ADJUSTMENTS SHOULD BE MADE BY ADJUSTING
THE GAS VALVE PRESSURE REGULATOR.
POSSIBLE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH MAY
OCCUR
IF THE CORRECT CONVERSION KITS ARE NOT INSTALLED. THE
APPROPRIATE KITS MUST BE APPLIED TO ENSURE SAFE AND PROPER
FURNACE OPERATION. ALL CONVERSIONS MUST BE PERFORMED BY A
QUALIFIED INSTALLER OR SERVICE AGENCY.
INLET GAS SUPPLY PRESSURE
TABLE 4
-
-
-
-
TABLE 5
To Next Page
Loading...
