PIX-75 www.amano.com/time • 1-800-253-9836 2-27
Note – A key is required to unlock the top cover which allows you
access to the ribbon cartridge for replacement and/or the
programming.
The Amano Part number for a replacement Ribbon Shield (see Figure 6) is
AJR-600600.
When ordering parts and/or accessories, be sure to include the PIX-75 model
number.
Error Messages
In the event of an error, a message will appear in the display. The possible
error messages are listed in the following table along with their probable
causes and solutions.
Note – An error message can be possibly cleared by pressing the
“Reset” button. The Reset button is located under the cover on top
of the clock (see Figure 7). The Rest button is recessed, so it will
require using an object such as the tip of a ballpoint pen to press.
For error messages Pr E 01 through Pr E 05, unplug the clock before
checking to see that the carriage is not stuck or jammed. Also, check to see
that the ribbon cables are in good condition. After clearing any jams, plug
the clock back in. Contact us at 1-800-253-9836 if you need assistance.
To Next Page
