Version 1.2 ©Copyright 2019, Ambient LLC. All Rights Reserved. Page 9
seals:
https://ambientweather.net/help/maintenance-floating-pool-and-spa-thermometers/
Silicone grease is available at most hardware and pool stores.
2.3 Display Console Set Up
2 Move the remote thermometer(s) about 5 to 10’ away from the display console (if the sensor is
too close, it may not be received by the display console). If you have more than one thermometer,
make sure they are all powered up and transmitting on different channels.
3 Remove the battery door on the back of the display, as shown in Figure 11. Insert four AAA
(alkaline or lithium, avoid rechargeable) batteries in the back of the display console.
Figure 11
All of the LCD segments will light up for a few seconds to verify all segments are operating properly.
4 Replace the battery door, and fold out the desk stand and place the console in the upright position.
The console will instantly display indoor temperature and humidity. The remote temperature
will update on the display within a few minutes on the appropriate channel.
While in the search mode, the remote search icon will be constantly displayed next to the
channel number.
If you have more than once remote sensor (up to eight remotes are supported), the display will
automatically toggle between sensors until all sensors have reported in.
Do not touch any buttons until the remote sensor has reported in, or the radio search icon is
no longer on, otherwise the remote sensor search mode will be terminated. When the remote
sensor temperature has been received, the console will automatically switch to the normal mode,
and all further settings can be performed.
If the remote does not update, please reference the troubleshooting guide in Section 6.
To Next Page
Loading...
Need help?
General
