14Lockit Users manual |
Good to Know: Plug and Play Timecode
Instead of using the graphical menu of the Lockit (pressing
Red & Green simultaneously) – feed in timecode and
frame rate externally. Just plug one Lockit to the TC Out port of
another device (e.g. your sound recorder) and it’s automatically
set and ready to sync – without any additional apps.
Just plug the Lockit to the TC Out port of another device (e.g.
your Sound Recorder) and it will automatically take over time-
code and frame rate.
This only works if no Single Jam has been sent - or a C-Jam / TX
Master is active in the ACN channel. Indicated by the LED ashing
red and green alternately.
If the device is already jammed and you attach an external time-
code source, you can enter the “Compare Screen”. This displays
a potential timecode drift between external source and your
Lockit.
To Next Page
Loading...
