Ambient Lockit - Connector Pinouts; Internal Buffer Battery

19Lockit Users manual |
11.2 Connector Pinouts
Blue ACN Connector and Yellow Sync Connector
Accept LEMO FGG.0B.305 and compatible push-pull plugs
Connectors carry TC in and out as per industry standard,
plus sync on one and ACN metadata on the other.
11.3 Internal Buer Battery
Your Lockit has an internal buer battery for the RTC (Real Time
Clock). It will only deplete when the unit is o with no NP-50 loaded and
last you a long time.
Once the Lockit doesn’t hold time it’s time to replace. The RTC allows you to set
the timecode to time of day.
First, get a CR2016 type battery. Remove NP-50 battery, slightly losen the
nut of the antenna socket by a half turn, and remove the 4 Torx 6 screws
on the back. Take o back cover, and slide out the covering lid as per print.
Replace battery and reassemble in reverse order.
Trilevel Sync Out Impedance 75Ω / Dual Load: 38Ω
LTC Out Impedance 1kΩ
LTC In Impedance 15kΩ
ACN SYNC (yellow cable)
1 GND GND
2 TC in TC in
3 ACN TX PPF out
4 ACN RX Sync out
5 TC out TC out
1
5
4
2
3