It is possible, and in some locations highly likely, that your radio will find more than
one wireless access point, in that case you can choose which one you want to
connect to. Turn the knob on the radio to see the ESSID for each access point the
radio has found.
Connecting to the wireless network
Please select by rotating knob one of the founded wireless networks ESSID and push
SELECT on the remote control or front device panel.
If your network is not configured to need an encryption code, the screen should
shows:
Connecting to Network
↓
Network OK
↓
Enter WEP (WPA) key
When the network is using one of the encryption systems: Wired Equivalent Privacy
(WEP) or Wi-Fi Protected Access (WPA). You therefore need to enter the correct WEP
or WPA code into the radio to get it to communicate with your network.
Only the person who set up the network in the first place knows this code; if that
person is not you then you need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use
the rotating knob to select each character of the code, pressing the SELECT button
after each character. Note that WEP and WPA codes are sensitive to upper and lower
case characters so you must enter them exactly.
After the final character, use the knob to select the END character and press the
SELECT button.
The radio stations finding
Press the SELECT button to return to the top-level menu and by rotating knob
find STATIONS submenu.
STATIONS
To Next Page
Loading...