Press SELECT button on the Set Alarm, after this you will see display like below.
< 1 OFF 00:00 Sunday >
Turn the knob to swap between the various alarms and Disable All.
Pressing the SELECT button on ‘Disable All’ will cause all the alarms turning off. In
this case the display will shows “All alarms disabled” and after 3 seconds, returns to
the radio station display.
All alarms disabled
Note: if you make a mistake at any point, press the BACK button to go back to the
previous screen.
If you select one of the numbered alarms, then the radio will allow to you select
the time for the alarm. In this case display will became like in picture below.
Set Alarm
15:06
Turn the rotating knob until the hour setting will become corrects, and then
press the SELECT button.
Set Alarm
07:06
Turn the rotating knob until the minutes setting will become corrects, and
then press the SELECT button
Alarm Set:
07:45
Turn the knob to choose between ‘Once’, ‘Every day’, ‘Weekly’, ‘Weekdays’ and
‘Weekends’ alarms presets. If you choose ‘Once’ or ‘Weekly’, then you will need to
choose which day you would the alarm to be activated. You can do this by pressing
SELECT button. Finally, you will need to select which type of alarm you would like to
use: the buzzer or a station that is assigned to a preset and then press the SELECT
button.
To Next Page
Loading...