Send Email: This checkbox allows the user to enable the system to send an email when a motion
detection alarm is triggered.
To refresh the page, click the Refresh button. To Save the settings click the Save button.
Network
This screen allows the user to specify actions that occur when there is an abnormality with the NVR’s
network connection. Below is a screenshot of the network abnormality settings screen:
Below is an explanation of the fields on the Network abnormality settings screen:
Event Type: This field allows the user to specify which Network abnormality event type they would like
to configure settings for.
Offline: The network connection has been disconnected.
IP Conflict: There is a device on the network with the same IP address.
MAC Conflict: There is a device on the network with the same MAC address.
Enable: This option allows the user to enable the features below for the specified event type.
Record Channel: This checkbox allows the user to enable the system to record video for that channel
when a motion detection alarm is triggered. Delay is also associated with this tab; it is the This field
specifies in seconds how long the delay between alarm activation and recording should be.
Alarm Tone: Check this box to enable an imported voice prompt to be used if an event occurs. To use
this feature, select a file from the dropdown box in the File Name section.
Show Message: This checkbox allows the user to enable the system to show an on-screen message
when an abnormality occurs.
Buzzer: Check this box to enable a buzzer to be sound on your device if an event occurs.
Log: Check this box to enable a log of the abnormality to be retained into the system.
More: Allows the user to access other detection options.
To Next Page
Loading...
