Note 2: If there is no programming command input in this time window, the ELT
will enter the Self-Test mode, and you cannot program the ELT. In this case,
set the ELT switch to “OFF” position and start again from step 2.2.
Figure 2
2.5 To program ELT: Use command “ 06 “
Important Instructions: Please provide the following information via
Email or fax or call Ameri-King, in order to obtain 22 Hex Digit ID:
Country
Protocol required (See Table 1 for List of all available Protocols)
24 Bit aircraft address, if applicable
Ameri-King shall then provide 22 Hex Digit ID (Short Message) or 30 Hex Digit ID
(Long Message) accordingly.
The “06” command syntax :
06 –s (-1/-22/-30) 123456789ABCDEF (0..F)
To program 22 Hex Digits ID to the ELT: (Short Messages)
At the command prompt type:
06 -22 XXXXXXXXXXXXXXXXXXXXXX
(Where X..X = 22 HEX Digits ID.) (See Figure 3)
To Next Page
Loading...