5
COMPONENT INSTALLATION
This section pertains to the installation of the air compressor, and other related items.
The instructions are intended as a guide to assist you with particular installation. These
instructions will provide only general information.
GENERAL INFORMATION:
To use the compressor, start the engine and engage the system with the compressor toggle
switch. Through the pressure switch the system will now function automatically. Once
engaged, adjust the engine speed control to ensure that the compressor speed does not exceed
1300 Rpm’s under load.
COMPRESSOR INSTALLATION:
Install compressor-mounting kit per manufacturer instructions. Set the compressor into place and
inspect for proper alignment. Readjust if necessary. Using four (4) cap screws, flat washers, and
nyloc nuts, secure the compressor in place. The compressor is air cooled, and must have a clean
supply of air. Adequate space must be provided for proper circulation of air.
To Next Page
Loading...
