American Range ARR-304DF - Performance Checklist; Start-Up Procedure; Operate

Medallion Dual Fuel Rangess
Use & Care Manual
13592 Desmond St., Pacoima, CA 91331 818.897.0808 tel 888.753.9898 toll free www.americanrange.com
14
PERFORMANCE CHECKLIST
AqualiedinstallershouldcarryoutthefollowingperformancechecksreferringtotheUserManualasnecessary:
Check operation of oven setting Bake at 350°.
Check operation of Broil function.
Checkoperationofalltopburnersathighandlowame.
Check operation of oven light using front panel control switch.
Check operation of the convection fan using front panel control switch.
Check operation of all indicator lights on control panel.
Beforecookinginyourovenforthersttimeremoveovenracksandwashthemwithhotsoapywater.Thoroughlyrise,dryand
replace them in the oven.
During initial start-up of the oven, after all performance checks and adjustments have been made, the oven should be allowed to
burn off any oils or solvents left from the manufacturing process. In any case, these materials are safe for the environment – but it is
besttheynotcontributetothetasteorodorofyourrstovencookingexperience.
OVEN BURN-OFF PROCEDURE
• Turn on the kitchen ventilating hood.
• Light the oven according to the instructions in the manual.
• Set the oven thermostat temperature to 350ºF.
• Let the oven run for one hour.
• Turn on the convection fan.
• Set the oven thermostat to 450ºF.
• Leave the oven operational for an additional hour.
• Shut off the oven by turning the thermostat to the OFF position.
BROILER BURN-OFF PROCEDURE
• Turn on the kitchen ventilating hood.
• Light the broil burner according to the instructions in the manual.
• Operate the broiler for ten minutes.
• Openthedoorbriey–abouttenseconds.
• Operate the broiler for an additional ten minutes.
• Shut off the broiler by turning the thermostat to the OFF position.
During the oven or broiler burn-off process, some strong odors or minor smoke may be experienced as remaining oils or solvents
on internal parts are oxidized. This is the primary reason for the burn-off process and should dissipate by the completion of the
time period.
RANGE START-UP PROCEDURE
0
0
0
0
0
0