American Standard 2050 - User Manual

T050.111
2050.111
2050.210
6-11/16"
9-1/8"
1-11/16" to 2-1/2"
TRIM KIT for CENTRAL
THERMOSTAT with VOLUME CONTROL
Installation
Instructions
M968417 REV 1.1
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
ASSE 1016
ROUGHING-IN DIMENSIONS
Recommended Tools
Flat Blade Screwdriver
Phillips Screwdriver
Remove as much surface dirt and film using clear
water and soft cotton cloth (as described above).
Use any of the following to remove tough surface
film and build-up:
Mild liquid detergents
Clear ammonia free liquid glass cleaners
Non-acidic, non-abrasive gentle liquid or fully
dissolved powder cleansers mixed according to
manufacturers directions.
Non-abrasive liquid polishers
Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.
To keep your new faucet looking new, please follow
these simple care instructions:
DO: Simply rinse the faucet clean with clear water.
Dry the faucet with a soft cotton cloth.
DO NOT:
Do not use any abrasive cleaners, cloths, or
paper towels.
Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
soaps.
Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
CARE INSTRUCTIONS:
Failure to follow these care instructions may
damage the Faucet's finish.
FINISHED
WALL
C
L
100
TO
P
/ O
P
E
N

Summary

Installation Overview and Care

Roughing-in Dimensions

Specifies the required dimensions for installing the faucet trim kit.

Recommended Tools

Lists the tools necessary for the proper installation of the faucet.

Care Instructions

Provides guidelines for maintaining the faucet's finish and preventing damage.

Installation Steps

Trim Installation

Steps for installing the trim components onto the valve body.

Handle Installation

Instructions for attaching the volume and temperature control handles.

Transposed Supply Piping

Procedure for correcting hot/cold water supply piping if transposed.

Temperature Calibration

Steps to calibrate the water temperature and set the hot limit stop.

Operating the Valve

Guidance on basic operation and troubleshooting common issues.

Parts Identification

American Standard 2050 Specifications

General

Brand	American Standard
Model	2050
Category	Thermostat
Language	English