American Standard TAM9A0B30V31DA User Manual

SSAAFFEETTYYWWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
April 2020
1188--GGJJ8822DD11--11EE--EENN
Variable Speed Air Handlers
Convertible 2 — 5 Ton
TAM9A0A24V21DA
TAM9A0B30V31DA
TAM9A0C36V31DA
TAM9A0C42V41DA
TAM9A0C48V41DA
TAM9A0C60V51DA
NNoottee:: “Graphics in this document are for representation
only. Actual model may differ in appearance.”
NNoottee:: For use with BAYEA series heaters ONLY
Installer’s Guide

American Standard TAM9A0B30V31DA Specifications

General

Model	TAM9A0B30V31DA
Type	Air Handler
Cooling Capacity	2.5 Tons
HSPF Rating	Up to 10
Refrigerant	R-410A
Blower Motor	Variable Speed ECM
Width (in)	21
Depth (in)	21
Phase	1
Motor Type	ECM
Air Flow Range	600-1200 CFM
Series	Platinum
Heating Capacity	30, 000 BTU/h
Nominal CFM	1, 000 CFM
Voltage	208/230V
Cabinet Type	Fully Insulated

Summary

SAFETY SECTION AIR HANDLERS

HAZARDOUS VOLTAGE!

Warning about high voltage risks during servicing.

GROUNDING REQUIRED!

Importance of proper grounding for safety and equipment.

LIVE ELECTRICAL COMPONENTS!

Warning about hazards of exposed live electrical parts.

PRESSURIZED REFRIGERANT!

Warning about high-pressure refrigerant hazards.

Unit Design

Unit Install Preparation

Optional Cabinet Disassembly

Placing Unit at Location

Setting the Unit - Vertical Installation

Setting the Unit - Horizontal Installations

Connecting the Duct work

Refrigerant Line Brazing

Condensate Drain Piping

Connect Condensate Drain Piping

Electrical — Low Voltage

Control Panel Reinstallation

Electrical — High Voltage

Display Assembly / Human Interface

TAM9 — Technician Menu and Configuration tree

System Charge Adjustments

System Start Up

TAM9 Sequence of Operation

Unit Test Mode

Procedure for running diagnostic tests on the unit.

Fault Reporting

Clearing Fault History

Methods for clearing active and historical fault codes.

Checkout Procedures