24
knee. They also add considerable margin to the voltage rating and reduce the time duration of
surges. See kit 811KS below.
Supply Rebuild Kit 811KS Filter Capacitors
This kit provides new bleeders, meter protection diode, filter capacitors, and meter multipliers.
All of the kit parts offer an improvement over factory parts.
I suggest surface soldering parts. As long as you make a good solid electrical joint with properly
flowed solder, the joint will have more than enough mechanical strength to hold components.
To install the capacitors and resistors “clear the board” of all the original parts you intend to
replace. Clear any holes where you want to mount with the lead through the hole:
Figure 35 clean off board
To Next Page
Loading...
