Ametek 7270 - Dual Reference Configuration Menu; Dual Reference and Dual Harmonic Modes Curve Select Menu

Chapter 5, FRONT PANEL OPERATION
5-72
5.5.10 Dual Reference Configuration Menu
Figure 5-55, Configuration Menu - Dual reference Mode
In dual reference mode, the Configuration menu appears as above. To leave dual
reference mode and return to single reference mode press the Single Reference key,
to switch to dual harmonic mode, press the Dual Harmonic key. The remaining
controls, and the Configuration Menu 2 accessed from this menu, operate as already
described in section 5.3.22
5.5.11 Dual Reference and Dual Harmonic Modes Curve
Select Menu
In the dual modes, when the Curve Buffer menu is displayed, pressing the Curve
select key accesses the Curve Select menu, which are shown in figures 5-56 and
5-57. The menus differ depending on the setting of the curve mode control on the
curve buffer menu.
Figure 5-56, Curve Select Menu - Standard Mode