Chapter 5, FRONT PANEL OPERATION
5-44
SAMPLE
A trigger output is generated each time that a point is acquired into the buffer.
TRIG OUT POLARITY
This control has two settings:-
RISING
The trigger output is marked by the rising edge of the signal.
FALLING
The trigger output is marked by the falling edge of the signal.
Pressing the Previous Menu key returns control to the Curve Buffer Menu.
5.3.27 Curve Select Menu
When the Curve Buffer menu is displayed, pressing the Curve select key accesses the
Curve Select menu, which are shown in figures 5-34 and 5-35. The menus differ
depending on the setting of the curve mode control on the curve buffer menu.
Figure 5-34, Curve Select Menu - Standard Mode
Figure 5-35, Curve Select Menu - Fast Mode
For the standard mode, this menu is used to select the instrument outputs that will be
To Next Page
Loading...