Ametek Powervar Security Plus II User Manual

40
A01-00150 Rev B
Symptom Possible Cause Remedy
Fault code is shown
The UPS shut down
Check output wiring and
as 14 on LCD display,
automatically because
if connected devices are
and alarm beeps
short circuit occurs on
in short circuit status.
continuously.
the UPS output.
Fault code is shown
as 01, 02, 03, 04,11,
12, 13, 14,1A, 21, 24,
35, 36, 41, 42 or 43 on
LCD display and alarm
beeps continuously.
A UPS internal fault has
occurred. There are two
possible results:
1. The load is still sup-
plied, but directly from
AC power via bypass.
Contact Technical
Support.
2. The load is no longer
supplied by power.
Battery backup time is
Batteries are not fully
Charge the batteries
shorter than nominal
charged.
for at least 7 hours and
value
then check capacity
again. If the problem still
persists, call Technical
Support.
Batteries defective.
Contact Technical
Support to replace the
battery.
The icon and
flash on LCD display
and alarm beeps every
Fan is locked or not
working; or the UPS
temperature is too high.
Check fans and contact
Techinal Support.
second.

Ametek Powervar Security Plus II Specifications

General

Brand	Ametek
Model	Powervar Security Plus II
Category	UPS
Language	English