Ametek Sorensen XG 12-70 - Table A-4 SCPI Commands for Calibration

A-18 M370430-01 Rev F
APPENDIX A SCPI Command Reference
Table A-4 SCPI Commands for Calibration
Function
SCPI Command
Description
Parameter and
Range
Query
Restore
Factory
Calibration
[:]CALibration[<channel>]:RESTore
Restores the calibration to the
factory defaults.
N/A
N/A
Restore
Default
Calibration
[:]CALibration[<channel>]:DEFault
Restores the default
calibration for all variables.
(Unit gain and zero offset).
N/A
No
Calibrate OVP
protection.
[:]CALibration[<channel>][:VOLTage] :P
ROTection[:OVER]
Calibrate the over voltage
protection.
<OVP Voltage Set in
Volts>
No
Enter Output
Voltage Data
[:]CALibration[<channel>]:OUTPut :VOLT
age
Sets the voltage output
calibration level.
<Voltage set in
volts>
No
Enter Output
Current Data
[:]CALibration[<channel>]:OUTPut :CURR
ent
Sets the current output
calibration level
<Current set in
amps>
No
Calibrate the
Voltage
controlled Non
Isolated
Voltage APG
feature
[:]CALibration[<channel>]:MONitor
[:VOLTage]
Calibrate the voltage monitor
signal system.
? | <NR1> | <nothing
for interactive mode>
Yes
Calibrate the
Voltage
controlled
Isolated
Voltage APG
feature
[:]CALibration[<channel>]:MONitor
[:VOLTage]:ISOLated
Calibrate the isolated voltage
monitor signal system.
? | <NR1> | <nothing
for interactive mode>
Yes