Rack Mount Options and Installation Instructions
M370430-01 Rev F E-19
to each computer that you will be using to access the XG unit
(s) over the Ethernet. If copying the files is not possible,
repeat step 3 for each computer that you wish to use.
The configuration is complete. You are now ready to use your system.
Controlling Your System
For every connected XG unit, create a separate terminal session.. Also,
open a separate HyperTerminal session for each XG unit that you wish
to control. An example of two units in a system is shown in Figure E-22.
Figure E-22 HyperTerminal Session
There are two HyperTerminal windows for controlling two power
supply units. See Figure E-23.
To Next Page
Loading...