Amica KMC User Manual

13
OPERATION
Switching on the appliance
When the appliance is switched off then all the
cooking zones are disconnected and the indicators
are off. Touch the on/off sensor eld (1) to switch
on the appliance. „0” will appear on all cooking
zone displays (3) for 10 seconds. Select cooking
zone by touching cooking zone selector sensor
eld (2) and then slide your nger across the
setting setting selection sensor eld (4) to set the
desired heat setting (see Selecting the cooking
zone heat setting).
If none of the sensor elds is touched within 10 seconds, the appliance swit-
ches itself off.
If child lock function is activated, the appliance cannot be switched on (see
„Releasing the child lock”).
Switching on the cooking zones
Control Panel
When the cooking surface is connected to the
electricity mains, the pilot light should light up
briey above the child lock sensor eld (7), after
which the appliance can be switched on.
No objects should be placed on the sensor elds (this could cause an error).
Touch sensor elds should be always kept clean.
After switching on the appliance using the on/off
sensor eld (1) cooking zones can be operated
as follows:
1. Select the desired cooking zone using the cooking
zone selector sensor eld (2). (Sensor eld layout
reects the layout of individual cooking zones),
2. To select the desired heat setting, slide your nger
across the setting selection sensor eld (4).
3. To change the heat setting again as described in
point 1, select the desired cooking zone using the
cooking zone selector sensor eld (2), and then
slide your nger across the heat setting sensor
eld (4).
If none of the sensor elds is touched within 10 seconds, the cooking zone
switches off.
A cooking zone is active when a dot is displayed by the number „ ” on the
cooking zone display. This indicates a cooking zone is ready for the heat setting
to be set or changed.
7
2
1
4
2
2
3
3
3
3
2
4
2
2

Amica KMC Specifications

General

Brand	Amica
Model	KMC
Category	Hob
Language	English